HEAT PRESS: Rotary Drum: 6572-30

Model 6572-30/60

Sheet-Fed or Roll-to-Roll

Rotary Heat Transfer Printer

MODEL 6572-30:

The 6572-30 (13'' dia. drum), has a belt speed of approximately 3.2 fpm with 40 second dwell time in the heat for digital printing applications. The AIT 6572-30 is specifically designed for digital dye sub printing of apparel and other industries that require cut-part, engineered prints. A new self-contained, oil-heated drum system assures uniform heat across the width of the cylinder and the lowest possible power consumption. AIT oil-heated drum systems use 50% less electric power than all electric machines.

AIT rotary heat presses with the new oil-heated drum system will increase production, reduce seconds, and save on energy costs. High productivity, quality engineering design, and conscientious after-the-sale service are all good reasons for investing with AIT for all of your dye-sub printing and textile dye fixation needs.

BACK TO MAIN

MODEL 6572-60:

The 6572-60 (24'' dia. drum), has a belt speed of 8.1 fpm with 40 second dwell time in the heat for digital printing applications. The AIT 6572-60 is specifically designed for high-production, off-set printing of apparel and other industries that require cut-part, engineered prints. A new self-contained, oil-heated drum system assures uniform heat across the width of the cylinder and the lowest possible power consumption. AIT oil-heated drum systems use 50% less electric power than all other electric machines.

FEATURES:

Oil-heated drum system that is fully contained and requires no pumps or rotary union joints while delivering perfectly controlled heat. (Less expensive machines have electric heat which require more power and less control of the heat.)
Two-mode loading conveyor which runs continuously or intermittently with a flip of a switch. (Less expensive machines have a loading table and the operator must push the paper into the nip allowing the possibility of part shifting.)
77" wide belt allows the possibility of two operators loading cut parts, doubling the production of more narrow machines. The transfer paper unwind allows the continuous feed of 72'' wide transfer paper to increase loading efficiency. (Less expensive machines do not have this feature.)
Three unwinds & three rewinds allow roll-to-roll fabric printing. (Less expensive machines have fewer unwind and rewinds and/or allow only cut sheet paper to be used.)
Lightweight aluminum body air shafts. (Less expensive machines use heavy steel shafts with tapered cones which can significantly reduce the amount of tension applied.)
Rewinds are independently controlled and have both speed and air clutch adjustability for maximum control. (Less expensive machines usually run at the same speed.)

Safety reversing lanyard across the entire entrance provides safety and assistance in loading the machine. (Less expensive machines do not have this feature.)
Air stripper bar is used for perfect separation of sheeted transfer paper and the cut fabric part, and eliminates seconds caused from paper movement and fabric shrinkage at the point of exit. (Less expensive machines do not separate in a positive manner and slide onto a tray greatly increasing the chance of a double image reject unless more expensive ''sticky'' paper is used.)
Exit conveyor system: after paper separation, the used paper falls into a box under the loading conveyor and the printed fabric part is conveyed to the back side of the machine where it is easily picked up and stacked or falls into a box. (Less expensive machines have the paper and fabric exit together and, in addition to the added risk of double imaging ghosting, the operator must reach up under the loading table to retrieve the printed part.)
Automatic cool down system. (Less expensive machines typically do not include this feature.)

PHOTOS & VIDEOS